다운로드
다운로드

매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.

다운로드 유형
모델 또는 키워드

When making a frequency measurement on an eye pattern+ why is the measurement reading 1/2 of the bit rate?

질문:

When making a frequency measurement on an eye pattern+ why is the measurement reading 1/2 of the bit rate?

답변:

Looking at an eye pattern, the bit rate is equal to 1/"eye" (one crossing point to the next crossing point). However, the frequency measurement equals 1/period (from one rising edge to the next rising edge). This is equal to two bits. The result is the frequency measurement, in this application, is equal to 1/2 the bit rate.

To verify this, turn on the annotations for the frequency measurement. Then turn on the cursors and place them across one eye pattern at the crossing points. The annotations will show where the frequency measurement was made; showing that from one rising edge to the next covered two bits. The cursor readout, 1/delta T will verify the frequency of one bit.

This setup highlights why the frequency measurement will read one half of the bit rate.

이 FAQ는 다음에 적용 됩니다:

제품 시리즈 없음

제품:

FAQ ID 63066

모든 FAQ 보기 »