다운로드
다운로드

매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.

다운로드 유형
모델 또는 키워드

What is the connection to get LTC into the WVR6000/WVR7000 series?

질문:

What is the connection to get LTC into the WVR6000/WVR7000 series?

답변:

An LTC is input through the 15-pin Remote connector on the rear panel. To input an LTC signal, you need to construct a cable.  This cable has four wires from the Remote connector, two to an RCA connector and two to a BNC.

Pin 7 of the Remote connector is connected to the center pin of the RCA connector, and pin 6 is connected to the shield of the RCA connector.

Pin 8 of the Remote connector is connected to the center pin of the BNC and pin 6 goes to the shield of the BNC.

LTC Signal Amplitude Range , 0.2 V p-p to 5.0 V p-p balanced differential or single-ended.

NOTE : Apply a signal to only one connector at a time.


이 FAQ는 다음에 적용 됩니다:

제품 시리즈 없음

제품:

FAQ ID 61216

모든 FAQ 보기 »