On my waveform monitor+ I cannot get it to see HD signals+ only SD signals. What is the problem?

Question:

On my waveform monitor+ I cannot get it to see HD signals+ only SD signals. What is the problem?

Answer:

The most common cause of this symptom is that the input loop-through is not terminated. Add a 75 ohm termination to the loop-through.

This FAQ Applies to:

Product Series: WVR7000/6000, WFM5000/4000

Product: WVR7100, WVR7120, WFM5000

FAQ ID : 60996

View all FAQs »
다운로드
다운로드

매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.

Go to top