연락처

텍트로닉스 담당자와 실시간 상담 6:00am-4:30pm PST에 이용 가능

전화

전화 문의 1-800-833-9200

9:00am-6:00PM KST에 이용 가능

다운로드

매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.

다운로드 유형
모델 또는 키워드

How do I set up a USB bus decode?

질문:

How do I set up a USB bus decode?

답변:

First you must have the USB module or option key that enables USB decoding for your scope as well as proper probes. For help finding the right probe use our probe selector tool. When you go into the bus option you must select USB and then make sure you select the right input channel and decode speed. Setting the correct threshold level is next since USB has a high and low level. 

A helpful part of doing USB decode is triggering. Normally you would trigger on an edge, but with the USB decode option you can set the scope to trigger on USB specific packets such as SYNC, DATA, EOF, SOF, ect. Watch this short video to see a demonstration of how to setup USB 2.0 decode on a MSO4000B series oscilloscope. A similar approach can be used for windows scopes. 

If you have questions please contact one of our Technical Support Centers and an Application Engineer will walk you through the procedure. 

 


FAQ ID 64726

모든 FAQ 보기 »