The "hardkey" command doesn't work on a VM700A+ what can I use instead?

Question:

The "hardkey" command doesn't work on a VM700A+ what can I use instead?

Answer:

The "hardkey" command was introduced on the VM700T and therefore is not available on the older VM700A's and VM700's.

Instead of using hardkey, you can use a combination of "hardpress" followed by "hardrelease" to achieve the same effect. The hardpress/hardrelease commands have other useful applications such as enabling the Y-C mode (normally done by holding one channel button while pressing another) by executing the following commands:

hardpress A

hardpress B

hardrelease B

hardrelease A

The above commands would enable the Y-C mode on channels A and B.

This FAQ Applies to:

Product: VM700A, VM700T

FAQ ID : 63971

View all FAQs »
다운로드
다운로드

매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.

Go to top