다운로드
다운로드

매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.

다운로드 유형
모델 또는 키워드

Why do some scopes trigger and/or decode I2C serial data as a 7 bit address and others as an 8 bit address? Why do some scopes trigger and/or decode extended I2C addresses as a 10 bit address versus a 16 bit address?

질문:

Why do some scopes trigger and/or decode I2C serial data as a 7 bit address and others as an 8 bit address? Why do some scopes trigger and/or decode extended I2C addresses as a 10 bit address versus a 16 bit address?

답변:

There are two ways to group I2C addresses for decoding: in 7 bits plus a read or write (R/W) bit scheme, and in 8 bits [a byte], where the R/W bit is included as part of the address. The 7 bit address scheme is the specified I2C Standard followed by firmware and software design engineers.

The 8 bit addressing scheme is followed by many IC manufacturers and hardware design engineers. The Tektronix DPO4000 series oscilloscope follows the adopted I2C Standard [7 bit] to trigger on and decode the I2Cserial data address in the packet. Examples showing you how to convert between a 7 bit-to-8 bit I2C address scheme follow.


이 FAQ는 다음에 적용 됩니다:

제품 시리즈 없음

제품:

FAQ ID 62396

모든 FAQ 보기 »