KR
현재 사이트
×
KR

경험을 사용자 정의할 지역을 선택하십시오:

메뉴 전환
KR
현재 사이트
×
KR

경험을 사용자 정의할 지역을 선택하십시오:

연락처

텍트로닉스 담당자와 실시간 상담 6:00am-4:30pm PST에 이용 가능

전화

전화 문의

9:00am-6:00PM KST에 이용 가능

다운로드

매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.

다운로드 유형
모델 또는 키워드

Floating Oscilloscope Measurements ... And Operator Protection


Oscilloscope users often need to make "floating" measurements where neither point of the measurement is at ground (earth) potential. "Signal common" may be elevated to hundreds of volts from earth. In addition, many of these measurements require the rejection of high common-mode signals1 in order to evaluate low-level signals. Unwanted ground currents can also add bothersome hum and ground loops. Too often, users resort to the use of potentially dangerous measurement techniques to overcome these problems.

  • Limitations of Traditional Oscilloscopes
  • Management and Safety in the Workplace
  • Floating an Oscilloscope: A Definition
  • Safety Engineering Principles
  • Safety - A Shared Responsibility
  • Battery-Powered Oscilloscopes
  • Monolithic Isolation Amplifiers
  • Differential Management System
  • Isolated-Input Oscilloscope

1 A "common-mode signal" is defined as a signal which is present at both points in a circuit. Typically referenced to ground, it's identical in amplitude, frequency, and phase. Making a floating measurement between two points requires rejecting the "common-mode signal" so the difference signal can be displayed.