Tektronix Receiver Test Application Software for USB3.1 Gen1 and Gen2 - V2.3.0

USB 3.1 Gen1 and Gen2: Testing is described in the USB-IF Compliance Test Specification (CTS) document. Receiver testing is accomplished by connecting the output of a BERT pattern generator as an input to the DUT, through a specialized set of fixtures and cables. The BERT is capable of producing specific USB 3.1 Gen1 and Gen2 test patterns and is capable of adding programmed amounts of random jitter, sinusoidal jitter, signal amplitude, and de-emphasis. The output of the DUT is then sent back to a BERT pattern error detector through a very clean return path, so that any errors detected can be assumed to have come from the forward path (as a result of the DUT experiencing a bad bit-decision). Receiver testing is performed by first calibrating the system as described in the CTS and then running JTOL test by sweeping different frequencies of sine jitter on top of random jitter and signal amplitude levels. These stressed signals are loop-backed by the DUT to the BERT where it counts and reports error, if any.

다운로드하면 소프트웨어 다운로드 계약 약관에 동의하는 것입니다.

This software applies to: BSX320, BSX240, BSX125, BSA286CL, BSA286C, BSA260C, BSA125C

다운로드
다운로드

매뉴얼, 데이터 시트, 소프트웨어 등을 다운로드할 수 있습니다.

Go to top